πŸ” Resolving Dynamic Indexing Dashboard Count Mismatches

Camilo Aponte

Camilo Aponte

Last updated on Nov 3, 2026

πŸ” Why the Count Looks Different

The dynamic indexing dashboard and the URL list are two different views of the same job. The dashboard shows a summary count, while the URL list shows each page individually. When the two appear to disagree, it usually means they were refreshed at different moments or are counting slightly different things.

πŸ“Š Common Reasons for the Mismatch

  • Timing lag: The dashboard summary can update on a short delay, so a page may show as deployed in the URL list before the counter catches up.
  • Pages awaiting a final check: A page can be deployed but still waiting for confirmation before it is counted as complete.
  • Filters or status views: The URL list may show all pages, while the dashboard counts only pages in a specific state.
  • Retries after a temporary issue: A page that failed once and was retried may be counted differently until the retry finishes.
  • Stale browser data: An older view of the platform can display outdated numbers.

βš™οΈ Step-by-Step: Find the Incomplete Pages

  1. Refresh the dynamic indexing dashboard and note the completed and total counts.
  2. Open the Site Audit URL/issue list and filter by status. Pages are not marked complete β€” look for pages that were not crawled or still have open issues.
  3. Compare the number of incomplete pages in the list with the difference shown on the dashboard.
  4. Wait a few minutes and refresh both views again, since counts often settle after a short delay.
  5. Clear your browser cache or open the platform in a private window if the numbers still do not match.

πŸ› οΈ What to Do If Pages Remain Incomplete

If the gap persists after refreshing, review each page that was not crawled or still has open issues. Confirm that the URL loads normally and is not blocked by a redirect, access rule, or error. Fix any issues you find, then allow the job to run again so the pages can be processed.

πŸš€ Tips to Avoid Future Mismatches

  • Check the dashboard after the job has had time to finish rather than immediately after starting it.
  • Use the URL list to confirm individual pages instead of relying only on a summary number.
  • Keep your page list current so pages are not added or removed in the middle of a run.

πŸ’‘ Frequently Asked Questions

Does a mismatch mean my pages are not indexed? Not necessarily. It usually reflects timing or status differences between the two views.

Will the counts ever match exactly? Yes. Once all pages finish processing and both views refresh, the numbers should align.

🀝 Getting Further Help

If you need further assistance, open the chat widget in the bottom-right corner of the platform and send your message. A member of our support team will reply in the chat.

Was this article helpful?