Home 🤖 OTTO SEO 🛠️ Fix a Stuck Domain Knowledge Network Rebuild

🛠️ Fix a Stuck Domain Knowledge Network Rebuild

Last updated on Nov 12, 2026

📌 What a stuck rebuild means

The Domain Knowledge Network is the map OTTO builds from your site so recommendations stay accurate. While a rebuild is running, the Domain Knowledge Network section shows "Preparing your knowledge network". If it makes no progress for 30 minutes, that screen changes to "This is taking longer than usual" and offers a Retry button. The project still exists, and the current network stays in place until a rebuild finishes.

🔍 Common reasons it stays stuck

  • A rebuild that is still running blocks a new one. If the rebuild never finishes, it stops blocking after it has made no progress, and you can start it again with Retry.
  • The site was slow to crawl, blocked the crawler, or returned many errors.
  • The domain, protocol, or trailing slash does not match the project URL.
  • Several rebuilds were started close together on the same project.
  • A temporary platform delay left the status unchanged after the work finished.

✅ Check the project before you retry

  1. Open the affected project and confirm the domain matches the live site, including https and the correct host.
  2. Note the current rebuild status and how long it has been unchanged.
  3. Confirm the site is publicly reachable and is not blocking crawlers.
  4. Avoid starting another rebuild until you finish the steps below.

🚀 Clear a stuck rebuild

  1. Refresh the project page. If the Domain Knowledge Network table and overview are showing instead of "Preparing your knowledge network", the rebuild has finished and no further action is needed.
  2. Wait at least 30 minutes if the rebuild started recently. Large sites can take longer.
  3. If the screen still says "Preparing your knowledge network" after that wait, refresh the project page. When it changes to "This is taking longer than usual", choose Retry once. Do not use Sync with Brand Vault for this, because that rebuilds a finished network and replaces it.
  4. Leave the project idle while the new job runs. Do not click rebuild again.
  5. Return later and confirm the "Preparing your knowledge network" screen is gone and the Domain Knowledge Network table and overview are showing.

⚠️ If it stays stuck after one retry

Do not queue repeated rebuilds. Extra attempts can keep the same job blocked. Check that the homepage loads, DNS points to the correct site, and important pages are not behind a login or hard block. If the domain recently changed, confirm the project URL was updated before you retry.

Share the project domain, the stuck status text, and roughly when the rebuild started when you contact support. That lets the team inspect the job without another customer-side retry.

💬 Contact support

If you need further assistance, open the chat widget in the bottom-right corner of the platform and send your message. A member of our support team will reply in the chat.